Teck rekt?
TECH REKT!
Teck rekt?
Other urls found in this thread:
...
...
is that a brake disk? lol
...
Haha yes... They used caliper paint and painted everything.
Good ol fashioned "good enuf" right there. Half surprised it isn't duct tape
all of these hurt
Please contribute even if its electronics
is this supposed to be a rotor? or what's left of a rotor i guess...?
...
Yes
checked
1h of grinding and it'll look fine
Lol yeap
...
OC from someone on facebook who decided to put racing seats in his POS but needed new seat rails so he made these himself
OP here, lol thanks, post more of his shit tier work
This is more troubling than any "gore" thread I've seen here
them installed
Rekt? That guy just added 50 HP to his Civic!
...
Throw in a few stickers and it will go even faster.
Holy fuck!!! I have never seen anything like that
Now it's silver paint.
Is that rice burner any fast?
what am i seeing?
is that the top of a piston that someone dropped a bolt into and ran the engine?
or fell into intake and wet through valve into combustion chamber
Im thinking they were just simply installing the head, and somehow a bolt landed in there as they were placing it and then torquing it.
those drain pans are fucking cancer
Is this the clutch material from a tranny?
...
...
it came from /k/ edition
i know nothing about cars and pimping, but that looks like it could fly on fire.
nice welds there.
I'm betting rear end oil or manual transmission oil.
I think they successfully used all the colors.
It's more about having wheelie bars and fat rear tires on a front wheel drive car.
...
what a fucking waste.
...
close enough
i dont get it....
Look, it glows in the dark.
(bad ground I think, but still)
RUN...
Is that what a cacodemon looks like on ps4?
christ, what a shit console
pc master race
...
>nice welds there.
Welds or JB weld that has been painted?
what is it
What the shit? With all that crap in there too...
Seems legit
The metal part on the top right is a break pad, it is supposed to move when you apply the breaks to the car so you can stop it, guess you won't be doing that anymore.
dont paint the area the break pads get pressed on, unless you want your breaks to fail.
LOL I hope this is real.
Audi drivers just can't handle it when the VTEC kicks in.
pardon my ignorance, but wouldnt the heat fuck up all that paint anyway?
what happened did it fall
Tech Gore*.
Ive just fixed that for you.
spray paint on the breaks increases the braking power
...Unless its coloured red!
Caliper paint is made with ceramic so it resists heat much better than other paints. Its also used on heads.
You know how brake pads touch the rotors a little bit even when your brakes are not applied?
You know how that robs you of about 30WHP and that is why WHP is so much lower than the normal horsepower that cars are advertised with?
You know how you can gain those 30HP back by coating your brake disks with high temp lithium grease?
Well that guy tried to do it with pain instead. Needless to say that didn't work.
actually lot of rust on broken part are making me think that it not only worked enough to drive to the service shop, but even convinced the driver to consider it "fixed"
haha #rekt and #gord
>mfw when you notice that this is not a 4 cylinder engine, but 5
>You know how you can gain those 30HP back by coating your brake disks with high temp lithium grease?
You should use graphite it will keep your race weight down.
oh
Epic
Fuck coilovers my ride is slammed!
I wish I could do that.
This triggers the Safety Nazi
...
Or maybe the stupid fuck just thought it would look rad
...
...
Turd-bo
>inb4 "I don't get it"
>inb4 millenials
could i use one of these to paint the exhaust of a motorcycle or will it get charred?
You can!
You can patch up that block with JB Weld. kek.
Oh god my brother did this long ago. Was a floppy though. I could have killed him.
use exhaust paint for exhaust
You're not that special because you know what a PC VHS tape looks like.....
>Magnets
This kills the disk
The paint will likely not allow the brakes to engage at all, the breaks are disabled in this case as the paint acts like a glue that makes the mechanism get stuck in the open position.
...
some OC
...
fuck off kid
Hi-octane, brutha!
with a hint of pre-detonation
Christ, is that the gas line glowing red hot?!
Fucking car was lime green, you know how hard it is to color coordinate your oil to a lime green car?
>being this mad you're not the only person here who knows what a greensquare disk looks like
Chill brah
...
im impressed by that motor
Nothing about that picture has anything to do with /k/. No one cares about your shitty board, dont bother mentioning it.
Must've been a hell of a bump.
Air cooling an engine is nothing new.
Is that fucking Mtn Dew coming out of there?
...
That filename lol
go back to you justin beaver sticker album