how much hp will my motor make.
351w
blue print 190cc heads
edelbrock cam .573 lift
performer rpm air gap intake
holley hp 750cfm
.030 over
How much hp will my motor make
Other urls found in this thread:
mustangandfords.com
twitter.com
Assuming a compression ratio and timing to run ~93 octane, you ought to be in the low 400's, no?
/o/
its 9.8:1 im shooting for 450
you think it will hold up to a 200 shot?
/o/ is a bunch or rednecks and ricers
Not a motor, it's an engine.
What's in the bottom end?
hypereutectic nothin special
About 450... About 425 at the wheels.
You're lookin at around 6000 rpm
Stall converter? Power band 3000 or so.
im gonna run a tci power glide. coil overs, all tubular susoension too. hopefully i do well in the 1/4
Quads of power.
yea 3000 stall should i spend the money on a trans brake instead of foot break?
Around 2.3 on the richter scale
Pics of what it's in?
You should... I'm gonna say 11's.
pics of my motor?
mustangandfords.com
Those Windsor motors have real strong low ends assuming it is an older block
think you lose more than 5% gettin to the wheels
More electric, more chance of issues.
its a 97 pretty new
The car or whatever you're running the 1/4 in
425 is not out of the question... Run low gears get out of hole fast utilize the power band to your advantage.
1990 foxbody mustang. file too large to upload
Tubes under the front? That will lighten you up.
>2017
>wanting serious whp gains
>not building a twin-turbo lsx
seriously?