Just built a computer won't turn on please help

Just built a computer won't turn on please help
My specs for refrence:
Radeon r9 390
I5 6500
Gigabyte H170-D3H
1TB HDD
2x 8 GB DDR4 2133 RAM
S340 Mid tower case
EVGA 500w 80+

Bump

Bumpp

Won't turn on or won't post?
Check everything is plugged in

It won't turn on I have checked all of the psu plugs

Bump please someone help?

Bump

Make sure the switch on your PSU is switched to ON.

Fuck off you retard you can't bump your own thread just by saying bump

Plug in the front panel connectors correctly faggot, I know for a fact that's your issue

OP I would've helped but you kept bumping like you had Alzheimer's so fuck off

look for the power button on your case. Trace the wire that is connected to it back to the motherboard. Plug it in correctly. press power

You have to reflow the solder on your motherboard. Put it in the microwave for exactly 20 seconds no more no less. This works like the Xbox towel trick.

Okay, I've ran into this problem too before, but when I found the solution, it was so easy and obvious I laughed at it.

Just find an extremely powerful magnet (fridge ones won't cut it, go for an electric powered one). Pass it over your motherboard, CPU, graphic card, everything. Pass it above them about 10 times for each part.

This will reset their clock, which will fix your problem. Since their internal clocks weren't synchronized, your PC wasn't turning on.

This. Made this mistake more times than I care to admit. Also double check all the connections.

I've seen this happen dozens of times. I work at a computer repair store, we see people like you all the time OP. The old magnet trick works every time. Something about using an AMD card with Intel CPU. Their clock cycles don't like to time correctly.

The clocks of the different components, that is. Forgot to write that up.

Be sure to tell us if we helped, OP.

edgelord detected

Turn off the motherboard and restart the router. Helped me.

No, you're the edgelord.

Why the fuck would you call someone giving legit advice an edgelord?

Have you tried turning the computer off and on again?

I want Sup Forums to leave.

Take the mobo out of your case, put it on a piece of cardboard, plug in the gpu one ram stick and the PSU.

Jump the power pins

I've heard whispers that asking an actual tech support forum is a pretty good idea.

Also, that magnet trick is legit, take your pick

If you think that isn't the most worn out troll on Sup Forums you're more summer than the smell of my ballsack in Florida heat.

Off yourself.

> ati housefire GPU
> only a 500w psu

there's your problem

Try jumpstarting it with a working computer, make sure the other computer is still running when you connect them.

If that doesn't work, check the belt or replace the starter.

This also happens if the cpu fan is not properly installed, same for the cpu

You forgot this case. That's why it won't turn on.

Check both ends.

nigga that system doesn't even pull 400W under full load.

unplug the 24 pin cable from the motherboard and plug it back in.

if it isn't all the way in then it won't power the computer